purchase of industrial grinding dust collector refers to the way to remove the dust adhered to the overconcern material (cloth bag or filter cylinder) according to the air compression of the gas producer; According to the size of the bag dust collector, there will be several pairs of pulse solenoid valves, operated by the dust removal pulse controller or PLC, each time open a set of pulse solenoid valves to remove the dust of the part of the bag or filter cylinder operated by it, and other cloth bags or filter cylinders are all working normally, and a set of pulse solenoid valves are opened after a period of time. The next part of the dust removal equipment is composed of a silo, an upper shell, a middle shell, a lower shell, etc. The upper, middle and lower shells are the condensate water system structure. When working, the smoke vapor body enters the bin from the air inlet pipe, the coarse and fine particles immediately fall into the bottom of the bin, the fine particles go up to the middle and lower shell with the turning point of the cyclone, the smoke accumulates in the outer surface of the dust bag, and the steam body after worry enters the upper shell to the purge combination pipe - exhaust system channel, and the air is discharged by the centrifugal fan. The whole process of ash removal is to disconnect the air duct at the exhaust inlet of the chamber first, so that the cloth bag of the chamber is in a non-cyclonic situation (condensate system reverse wind ash removal). Then the pulse solenoid valve is opened to carry out the single pulse gas producer ash removal with air compression, and the closing time of the emergency shutdown valve can be determined to settle the dust foundation from the dust bag after the gas producer settles to the bin, preventing the dust from getting rid of the dust bag surface and then collecting to the adjacent dust bag surface with the cyclone, so that the dust bag is cleaned and clean. The automatic exhaust valve, pulse solenoid valve and star discharger are operated automatically by the programmable temperature controller. When the smoke and dust vapor body enters through the air inlet and passes through the bin, part of the large particulate dust in the vapor body is extracted by the inertia moment and the effect of the force, and immediately falls into the bottom of the bin. The dust vapor body enters the dust bag filter area of the middle shell at the back of the bin, passes through the filter screen, and the dust is blocked to the outer surface of the dust bag. After cleaning, the steam body enters the upper shell through the mouth of the dust bag, and then is discharged by the air conditioning outlet.

The key function of the air bag in the purchase of industrial grinding dust collector is to store a sufficient amount of air compression to determine the smooth working pressure of the gas path, and also has the effect of sewage treatment. A good method is to install the air bag of the dust removal equipment on one side of the two sides of the monopulse cloth bag type dust collector. If the air bag is installed at the front end of the clean brake air chamber of the bag filter, the indoor space of the bag chamber matching the bottom of the bag bag of the dust removal equipment cannot be installed, and the indoor space of the bag chamber is wasted. The gas is packaged in the middle of both sides of the bag dust collector, because the gas is packaged on both sides of the bag room, the indoor space of the bag room is flexibly used, the same over-anxious total area of steel consumption is reduced, and the elbow part of the blowpipe of the spray boiler is exposed to the outside of the net brake air chamber, and the engineering construction and installation is more convenient. Therefore, people should choose the side way to install the air bag as much as possible.

The size of the air leakage rate after the dust collector is that the air tightness of the dust collector is fully considered in the design.

purchase of industrial grinding dust collector https://www.kaisenfilter.com/KSZHDM-01-Combined-Grinding-Dust-Collector.html